Maintenance / Warranty Conditions - Migatronic FOCUS MIG2 300 Betriebsanleitung

MAINTENANCE
The machine requires periodical maintenance and
cleaning in order to avoid malfunction and cancellation
of the guarantee.
WARNING !
Only trained and qualified staff members can carry
out maintenance and cleaning. The machine must
be disconnected from the mains supply (pull out
the mains plug!). Thereafter, wait around
5 minutes before maintenance and repairing, as all
capacitors need to be discharged due to risk of
shock.
Power source
Clean the fan blades and the components in the
-
cooling pipe with clean, dry, compressed air as
required.
A trained and qualified staff member must carry out
-
inspection and cleaning at least once a year.
Wire cabinet
- Regularly, clean the wire cabinet with compressed
air and check if the grooves and teeth on the wire
drive rolls are worn out.
Cooling unit
Liquid level and frost protection must be checked
-
and cooling liquid refilled as required.
Drain the cooling liquid out of the cooling module
-
and welding hoses. Remove dirt and flush with
pure water in the tank and cooling hoses. Fill up
with new cooling liquid. The machine is delivered
with a cooling liquid of type propan-2-ol in the ratio
23% propan-2-ol and 77% demineralized water,
which provides an anti-freeze solution up to –9°C.
(See article number in the spare parts list).
CONDITIONS OF WARRANTY
Migatronic continuously carries out quality control
throughout the manufacturing process as well as
check of the complete units through comprehensive
testing.
Migatronic provides warranty in accordance with the
following provisions, by correcting errors and defects
on units, that demonstrably and within the warranty
period may have been caused by faulty material or
workmanship.
The warranty period is 24 months for new welding
machines, 12 months for new accessories and 6
months for spare parts. The warranty period is
calculated from the date of invoice to the end user
from Migatronic or Migatronic's dealer/distributor. In
the case of sales through Migatronic's
dealer/distributor, the warranty period expires in any
event within 36 months for new welding machines and
30 months for spare parts from the date of invoice
from Migatronic to the dealer/distributor. This
extension in no way extends the warranty period. The
original invoice is proof of the warranty period.
Welding torches are considered as wearing parts, and
only errors and defects found within 6 weeks upon
delivery and due to faulty material or workmanship,
will be considered under warranty.
Warranty repairs neither extend nor renew the
warranty period.
Any transport of goods or persons in connection with a
warranty claim is not covered under Migatronic's
warranty obligation and will therefore be at the buyer's
expense and risk.
Please also refer to www.migatronic.com/warranty
24