Software - Migatronic FOCUS MIG2 300 Betriebsanleitung

In case of exchange of the control unit, software must
be reloaded, using an SD card.
Latest software can be downloaded under Product
software at www.migatronic.com/login. Save the
software on an SD card containing the folders and one
or more of the files shown below.
To order SD card, use item no. 12646000.

SOFTWARE

Software reading FOCUS MIG
 Insert the SD-card in the slide in the right side of
the machine.
 Turn on the machine.
 The display flashes shortly with three lines.
 Wait until the set current is displayed.
 Turn off the machine and remove the SD card.
 The machine is now ready for use.
Software reading FOCUS MIG
 Insert the SD-card in the slide in the right side of
MWF 27
 Turn on the machine.
 The display flashes shortly with three lines.
 Wait until the set current is displayed.
 Turn off the machine and remove the SD card.
 The machine is now ready for use.

All machine user settings are deleted when
new software has been inserted. Therefore,
always remove the SD-card from the machine
after the software update. Thereby, continuous
software update is avoid each time the machine
is turned on.
19
2
300
2
400
2
.