28 www.electrolux.com
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the nat-
ural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The Af-
ter Sales Service specialist will carry out
the reversibility of the doors at your cost.
8.5 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic
9. NOISE
There are some sounds during normal
running (compressor, refrigerant circula-
tion).
1
3
1
2
• Unscrew the screws of the door top
hinge.
• Remove the hinge. Put over the pin in
2
the direction of the arrow. Install the
hinge on the opposite side.
• Tighten the hinge.
• Put the top in position.
• Pull it forward.
• Screw both screws on the rear side.
• Remove and install the handle (if foree-
sen) on the opposite side.
• Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
power supply socket is not earthed, con-
nect the appliance to a separate earth in
compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibili-
ty if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.