Multichannel Systems; Operating Notes; Selecting Modes; Selecting Screens - AKG WMS4000 Bedienungsanleitung

3. Turn the SETUP control CW or CCW to select the desired squelch threshold. You can select between
"TCSQ" (automatic Tone Code Squelch) and several preset values.
4. Press the SETUP control briefly. The display will change as follows:
• To save your setting, press the SETUP control briefly. The display will revert to the Squelch screen.
• If you'd rather not save your setting, turn the SETUP control CW or CCW. The display will change as
follows:
- Press the SETUP control briefly. The display will revert to the Squelch screen.
1. Be sure to assign a separate carrier frequency to each wireless channel (transmitter and receiver).
2. To find intermodulation-free carrier frequencies quickly and easily, we recommend using Auto Preset
to select all required carrier frequencies from the same Frequency Group within the same Preset.
If reception on the selected carrier frequency is poor, use Auto Channel Setup to find the next clean
Subchannel within the selected Frequency Group. Should you find no clean Subchannel, use Auto
Group Setup to select a different Frequency Group within the same Preset and selecet a new fre-
quency for each WMS 4000 channel (refer to sections 3.8.1 and 3.8.2).
3. Do not operate two or more wireless channels on the same frequency at the same time and location.
This would cause unwanted noise due to radio interference.
To toggle between LOCK and SETUP modes, press and hold the SETUP control for approximately 1.5
seconds.
When the receiver is in LOCK mode, the "LOCK" label is shown on the display. In SETUP mode, the
"LOCK" label is not shown.
In LOCK mode, you can only call up the following status screens:
- Preset
- Frequency
- Name
- Battery life
1. To call up the status screens in the above order, turn the SETUP control CW.
The last screen is followed by the first.
2. To call up the status screens in reverse order, turn the SETUP control CCW.
The first screen is followed by the last.
The following setup screens are available in SETUP mode:
- Auto Group Setup
- Auto Channel Setup
- Preset
- Frequency
- Name
- Environment Scan
- Squelch Threshold
- Rehearsal
- Extra
Each screen provides one or two submenus for you to make your adjustments.
1. To call up the setup screens in the above order, turn the SETUP control CW.
The last screen is followed by the first.
2. To call up the setup screens in reverse order, turn the SETUP control CCW.
3 Setting Up

3.10 Multichannel Systems

Note:

4 Operating Notes

4.1 Selecting Modes

4.2 Selecting Screens

4.2.1 LOCK Mode

4.2.2 SETUP Mode

37