Selecting Frequencies For Multichannel Systems (Auto Channel Setup) - AKG WMS4000 Bedienungsanleitung

7. As soon as the receiver has found a clean frequency, the Subchannel number assigned to this fre-
quency will be displayed. The SETUP control will not respond to turning. The NAME, GROUP, and
CHANNEL fields will be flashing:
8. Press the SETUP control briefly. The display will change as follows:
• To save your setting, press the SETUP control briefly. The display will revert to the Auto Group Setup
screen.
• If you'd rather not save your setting, turn the SETUP control CW or CCW. The display will change as
follows:
- Press the SETUP control briefly. The display will revert to the Auto Group Setup screen.
9. If the receiver finds no clean frequency, the display will look like this:
- Press the SETUP control briefly. The display will change as follows:
• If you want to try again, press the SETUP control briefly and repeat steps 3 through 6 above.
• If you prefer not to start a new frequency search, turn the SETUP control CW or CCW. This will bring
up the "EXIT" option:
- Press the SETUP control briefly. The setting will not be saved and the display will revert to the Auto
Group Setup screen.
• Select the frequency of the first receiver using the Auto Group Setup screen (refer to section 3.8.1
above).
• Switch ON any radio microphones, personal monitor transmitters, etc. (including even those
made by other manufacturers)! This is the only way to make sure the receiver will find frequen-
cies that will be free of any mutual interference during the performance.
• Tune the transmitter assigned to the receiver to the same frequency that you selected on the receiv-
er and switch power to the transmitter on.
• Set all other receivers to the same frequency GROUP as the first receiver and use the Auto Channel
Setup screen to automatically find the optimum frequency (CHANNEL) for each receiver:
1. In SETUP mode, turn the SETUP control CW or CCW to bring up the following screen:
3 Setting Up
3.8.2 Selecting Frequencies
for Multichannel Systems
(Auto Channel Setup)
29