AKG WMS4000 Bedienungsanleitung Seite 35

3 Setting Up
Interrupting the scan
34
• To exit Environment Scan, turn the SETUP control CW or CCW. The "EXIT" option will appear on the
display and start flashing:
- Press the SETUP control briefly. The display will revert to the Environment Scan screen.
4. Once the scan has reached the Stop frequency, the scan is automatically stopped and the message
"READY" appears on the display.
5. To view the first item on the scan list, press the SETUP control briefly. To scroll through the other items,
turn the SETUP control CW or CCW.
An interference source can be a single frequency as in example 1 or a frequency band as in example
2 below. The RF meter on the display indicates the noise level of the scanned frequency or band.
Example 1: A noise level of -90 dB has been found on the receiving frequency of 762 MHz.
Example 2: A max. noise level of -80 dB has been found in the 764 MHz to 767 MHz band.
The last item on the scan list is the "EXIT" option.
6. To scroll through the list again, turn the SETUP control CW or CCW.
To return to the Environment Scan screen, press the SETUP control briefly.
• You can interrupt the scan at any time by pressing the SETUP control briefly. If you do, the message
"PAUSED" will appear on the display.
• To view the the scan list, press the SETUP control briefly. You can scroll through the items on the list
by turning the SETUP control CW or CCW.
• Press the SETUP control briefly. The display will offer the "CONT" option.
• To resume the scan, press the SETUP control briefly.