Connecting The Power Supply; Troubleshooting - Medion MD 30217 Bedienungsanleitung Zur Schnellen Installation

C VGA S
ONNECT THE
3. Plug the signal cable into the matching VGA port on the computer.
C A
ONNECT THE UDIO
4. Plug the audio cable into the matching ports on the computer and on the monitor. This should be "audio out", "line out"
or "speaker" on your computer.
C
ONNECTING THE
5. Now connect the mains socket of the monitor using the mains cable supplied with a properly configured mains outlet.
The outlet should be near the monitor and ease to access. (same circuit).
6. Your monitor features a power switch for turning your monitor on and off. If the switch is set to 0, then no power is
consumed. Set the switch to I and next switch your monitor on using the on/off switch.
7. Then switch on your computer.
Controls
Menu/Enter
Down
Decrease volume
Up
Increase volume
Auto
Operation indicator
Power

Troubleshooting

It can be difficult to check some of the settings listed below if your display is blank! In order to get an image on your screen
so that you can check the settings, it may be necessary to start your computer in safe mode.
Windows 98/ME.
When starting your computer, press F8 before the Windows logo screen appears. Select Safe Mode.
Windows NT 4
When starting your computer, select the boot option with [VGA Mode] at the end.
Windows 2000/XP
When starting your computer, press F8 before the Windows logo screen appears. Select Enable VGA mode.
It may be necessary to reinstall your video driver while in one of these modes in order to reset the resolution and refresh rate.
No display on screen:
Check:
Refresh rate frequency. The current image refresh frequency must be suitable for the TFT monitor.
Power saving mode. Press any desired key and move the mouse to deactivate the mode.
Signal cable pins. If pins are bent, please contact your call center.
Set the appropriate values for your TFT monitor.
Picture runs or is not stable:
Signal cable pins. If pins are bent, please contact your call center.
Video card. Check whether the settings are correct.
Image refresh frequencies. Select permissible values for your graphic settings.
Remove any interfering equipment (portable telephones, loudspeakers, etc.) from the vicinity of your TFT monitor.
Avoid using monitor extension cables.
Colors not displayed cleanly:
Check the signal cable pins. If pins are bent, please contact your service dealer.
Readjust the color settings using the OSD.
Avoid using monitor extension cables.
2
C
IGNAL ABLE
C ( )
ABLE OPTIONAL
P S
OWER UPPLY
When this key is pressed the OSD (ON screen display) starts on your LCD monitor Confirm you
selection by pressing this key.
When OSD is active this key sets a parameter value and decreases it.
Executing it directly lowers the volume.
When OSD is active this key sets a parameter value and increases it.
Executing it directly raises the volume.
With this key you can automatically adjust the image.
Indicates the operating state.
Blue = Normal mode,
Orange = Stand-by mode
With this switch you can switch the LCD monitor ON and OFF.
E E
N N G G L L I I S S H H