Back Connections; Connecting The Monitor; Connect Signal Cable; Connect Audio Cable - Medion AKOYA E54001 Anleitung

Back Connections

Power supply (POWER IN)
1.
3.5 mm stereo jack audio connection (AUDIO IN)
2.
DVI-D 24-Pin connection (DVI)
3.
Mini 15-pin D-sub connection (VGA)
4.
Intake device for protection against theft (Kensington lock)
5.
Speakers
6.

Connecting the monitor

Please read the "Safety information" chapter (from page 3), in order to bring the TFT monitor into operation
immediately.
We recommend that you also read the other chapters, in order to receive detailed explanations and operating
instructions for your TFT display unit.
 Ensure that the TFT monitor has not yet been connected to the electricity supply (mains plug not yet
plugged in) and that neither the TFT monitor nor the computer has been switched on.
 Prepare your computer for the TFT monitor if necessary, so that the correct settings for it will be present.

1 Connect signal cable

 Plug the signal cable into the appropriate VGA or DVI connections on the computer and the TFT monitor.

2 Connect audio cable

 Plug the audio cable into the appropriate audio sockets on the computer and the TFT monitor.

3 Connect the power supply

 Now connect one end of the mains cable supplied with the device to TFT power supply connection and
then the other end to an appropriate socket. The mains socket must be in the vicinity of the TFT monitor
and be easily accessible (use the same electricity circuit as for the PC).

4 Switch on the monitor

 Switch your monitor on at the Standby/On switch on the front of the device. Finally, switch your computer on.
(Ill.: Back of the monitor)
Bringing the device into operation
DE
EN
FR
ES
IT
NL
DK
9