Connections On The Back; Connecting The Monitor; Connect Signal Cable; Connect Audio Cable - Medion MD Business P54017 Bedienungsanleitung

Connections on the back

POWER switch
1.
Power supply (POWER IN)
2.
3.5 mm stereo jack audio connection (AUDIO IN)
3.
DVI-D 24-Pin connection (DVI)
4.
Mini 15-pin D-sub connection (VGA)
5.
Intake device for protection against theft (Kensington lock)
6.

Connecting the monitor

 Ensure that the TFT monitor has not yet been connected to the electricity supply (mains plug not yet
plugged in) and that neither the TFT monitor nor the computer has been switched on.
 Prepare your computer for the TFT monitor if necessary, so that the correct settings for it will be present.

1 Connect signal cable

 Plug the signal cable into the appropriate VGA or DVI connections on the computer and the TFT monitor.

2 Connect audio cable

 Plug the audio cable into the appropriate audio sockets on the computer and the TFT monitor.

3 Connect the power supply

 Connect the power cable of the power pack to the TFT electricity supply connection.
Now, connect one end of the mains cable to the power pack and connect the other end to a suitable socket.
The mains socket must be in the vicinity of the TFT monitor and be easily accessible (use the same electricity
circuit as for the PC).

4 Power on

 The TFT-display can be powered on or off using the power switch on the back. If the switch is set to OFF, no
power will be consumed. First set the power switch to I, next activate the display with the on/standby
switch on the front and then power on your computer.
(Ill.: Rear of the monitor)
Bringing the device into operation
9