Cd Programming; Playback Of Mp3 Via Usb Storage Media - auna KR-500 Bedienungsanleitung

CD PROGRAMMING

Up to 20 tracks can be programmed for disc play in any order. Before use,
be sure to press hold second the "stop" button.
1. Set in CD mode & stop the CD playback.
2. Press hold the " Info/CD MEM " button and " program " will appear on
LCD display (1).
3. Select a desired track by pressing skip up or down button (15/20).
4. Press the " Select " button (4) to store the track into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if
necessary.
6. When all the desired tracks have been programmed, press " Play/Pause
" button (16) to play the disc in assigned order.
7. Press hold second " Stop" button (16) to stop playback, press hold
second Stop button again to clear all stored memory.
The programming mode will automatically stop if no button is being
pressed in a period of about 10 seconds after pressing the " Info/CD MEM "
button.

PLAYBACK OF MP3 VIA USB STORAGE MEDIA

Connecting
The system is able to decode and playback all MP3 file which stored in the
memory media with USB connecting port.
1. Set the system at Standby mode first or other function except USB
mode.
2. Plug-in the USB pen-drive with the face up & make sure it going into
completely.
Plug-in the USB pen-drive with the face up & make sure it going into
completely.
Connecting the USB upside down or backwards could damage the audio
system or the storage media (USB thumb driver). Check to be sure the
direction is correct before connection.
3. Turn on the unit again by On/off button and set press Function button
to select USB mode. The system will start reading the storage media
automatically after connecting, and LCD display (1) will show the total
number of MP3 files being detected.
4. Repeat the same playback procedure as playing CD/MP3 disc as above.
EN
31