Cd Programming; Playback Of Mp3 Via Usb Storage Media - auna KR-400 Bedienungsanleitung

EN
32

CD PROGRAMMING

You can listen the desired track, folder(for MP3 only) or whole disc repeat
by this function.
1. Set in CD mode & stop the CD playback.
2. Press the " Mem/Clk-Adj " button (8) and " MEM " will appear on LCD
display (1).
3. Select a desired track by pressing skip up or down button (16/21).
4. Press the " Mem/Clk-Adj " button (8) to store the track into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if
necessary.
6. When all the desired tracks have been programmed, press " Play/Pause "
button (17) to play the disc in assigned order.
7. Press " Stop " button (19) to stop playback, press Stop button again to
clear all stored memory.
The programming mode will automatically stop if no button is being
pressed in a period of about 10 seconds after pressing the "Mem/Clk-Adj "
button.

PLAYBACK OF MP3 VIA USB STORAGE MEDIA

Connecting
The system is able to decode and playback all MP3 file which stored in the
memory media with USB connecting port.
1. Set the system at Standby mode first or other function except USB
mode.
2. Plug-in the USB pen-drive with the face up & make sure it going into
completely.
Plug-in the USB pen-drive with the face up & make sure it going into
completely.
Connecting the USB upside down or backwards could damage the audio
system or the storage media (USB thumb driver). Check to be sure the
direction is correct before connection..
3. Turn on the unit again by On/off button (14) and set press Function
button (15) to select USB mode. The system will start reading the storage
media automatically after connecting, and LCD display (1) will show the
total number of MP3 files being detected.
4. Repeat the same playback procedure as playing CD/MP3 disc as above.
Remarks