auna KR-500 Bedienungsanleitung Seite 27

Connection and getting started
1. Insert the DC plug of provided AC/DC adaptor to the DC jack (23) of the
main unit, then connect the AC/DC adaptor to AC outlet.
2. When you first plug the unit into the mains, the display (1) will show
"STARTING..."
3. After few seconds, unit will go to Setup wizard mode automatically when
first time connect to the AC source and display will show "Start now?"
and default at "YES" state. Press Select button (4) to start Setup the
wizard.
4. Then unit will show clock format, press Left/Right button (19/17) then
press the Select button (4) to confirm the clock format.
5. Then unit will enter Auto update mode, press Up/Down button (8/3)
to select update source then press the Select button (4) to confirm and
enter to time zone mode.
6. Press Up/Down button (8/3) to select time zone then press the Select
button (4) to confirm and enter daylight saving mode.
7. Press Left/Right button (19/17) then press the enter button (4) to confirm
the daylight saving mode to confirm and enter to Network setting mode
and default in "YES" state. Press Select button (4) to confirm and unit will
enter Wilan region mode and default at "Europe".
8. Press Select button (4) to confirm the region then unit will start to
searching the router of your area and then will listed SSID on the LCD
display (1).
9. Select the router by Up/Down button (8/3) then press Select button (4)
to confirm.
EN
27