Klarstein 10032975 Handbuch Seite 19

3. Drill a hole in the cabinet, which will later guide the power cord.
4. Remove the screws on the frame (B) and unscrew the two lamps. Ensure that the two
clips on both sides of the hood are suitable for the thickness of the area where the
hood is installed. If this is not the case, adjust the clips using the screws.
5. Lift the hood to the opening in the wall cabinet, then pass the power cord through
the opening drilled in step 3.
6. Slide the hood completely into the opening in the wall cabinet. If you want to connect
the extraction hood to a pipe leading outwards, attach the connecting pipe at the top
of the round air outlet of the extraction hood. While one person is holding the hood,
the other person tightens the screws through the holes in the hood frame (A).
7. Then screw the fan frame (B) back on and tighten the two lamps.
8. Finally, reinstall the grease filter.
EN
19