Replacing The Battery - Silvercrest SPWG 180 E5 Bedienungsanleitung

SilverCrest SPWG 180 E5

Replacing the battery

Replace the battery when it is empty. To replace the lithium battery
CR2032, open the cover of the battery compartment (4) at the rear
of the bathroom scales by slipping your finger into the slot on the side
of the battery compartment (4). Now remove the cover of the battery
compartment (4).
To remove the battery, push it down a bit (see the direction of the
arrow in the illustration). You can then remove the battery from the
holder.
Then insert a new lithium battery CR2032. Pay attention to the
polarity when inserting the battery. This is indicated in the battery
compartment (4), and the + symbol on the lithium battery CR2032
must be visible, as shown in the adjoining illustration.
Then replace the cover on the battery compartment (4). The
bathroom scales are now ready to use.
English - 21