Function; Safety Instructions; Hazard Levels; Symbols On The Machine - Kärcher PC 100 M1 Bio Bedienungsanleitung

Function

The detergent in the container is heated by
the heating element and transported by the
pump to the cleaning tools. These can then
be controlled via the corresponding shut-off
valves.
Solid dirt particles are held back by the
sieve in the rinsing floor or in the underlying
filter mat.
Grease and oily dirt is rinsed back into the
container and is there degraded by the mi-
crobes into carbon dioxide and water.
The microbes are first caught in the filter
mat and are then transported by the liquid
detergent into the container. The liquid de-
tergent must be heated in the container so
that the microbes can function optimally.

Safety instructions

– Please read the operating instructions
for your machine before using it, and
pay particular attention to the following
safety instructions.
– Warning and information plates on the
machine provide important directions
for safe operation.
– In addition to the information contained
in the operating instructions, all statuto-
ry safety and accident prevention regu-
lations must be observed.

Hazard levels

DANGER
Pointer to immediate danger, which leads
to severe injuries or death.
WARNING
Pointer to a possibly dangerous situation,
which can lead to severe injuries or death.
CAUTION
Pointer to a possibly dangerous situation,
which can lead to minor injuries.
ATTENTION
Pointer to a possibly dangerous situation,
which can lead to property damage.
16

Symbols on the machine

!

Power connection

DANGER
Danger of injury by electric shock.
The appliance may only be connected to al-
ternating current.
The appliance may only be connected to an
electric supply that has been installed by an
electrician in accordance with IEC 60364.
The voltage indicated on the type plate
must correspond to the voltage of the elec-
trical source.
It is imperative to connect the appliance to
the electric mains by means of a plug. It is
forbidden to permanently connect the appli-
ance to the power supply. The plug serves
for the disconnection from the mains.
Check the power cord with mains plug for
damage before every use. If the power cord
is damaged, have it replaced immediately
by the authorised customer service/electri-
cian in order to avoid possible hazards.
– It is recommended that you connect this
device to a socket that has a 30 mA pro-
tection switch against wrong currents.
– Please use the mains cable prescribed by
the manufacturer; the same is also appli-
cable when you replace the cables. For
type details see spare parts list.
– Never touch the mains plug with wet
hands.
– Make sure that the power cord or exten-
sion cables are not damaged by run-
ning over, pinching, dragging or similar.
Protect the cable from heat, oil, and
sharp edges.
– The extension cable must have the cross-
section listed in the circuit plan and be
protected against spraying water. The
connection must not lie in water.
– 2
EN
DANGER
Risk of electric shock. The
casing must only be opened
by electricians.