Technical Data; Important Information - Austro Flamm Mr. Wu Benutzerhandbuch

english

2. TECHNICAL DATA

As a stove of construction type 1, it is possible to connect it
to the chimney together with an existing other stove or
Technicla data Mr. Wu
Height [mm]
Width [mm]
Depth [mm]
Weight [kg]
Flue pipe outlet Ø [mm]
Nominal thermal output [kW]
Max. thermal capacity [kW]
Min. heating capacity [kW]
Room heating capacity (
depending on building insulation
Efficiency [%]

3. IMPORTANT INFORMATION

Die Informationen in diesem Handbuch sind allgemeiner
The installation and operation information given here is of
general nature. National and European standards, local and
building regulations as well as fire prevention laws must be
observed during the operation of the stove.
General safety instructions for the
operation of your stove

Read the entire manual before starting up your stove
thoroughly and observe the caution notices.

Your heating unit must not be moved without approved
means of transport with sufficient load-bearing capacity.

Your heating unit is not suitable to be used as a stand or
as a ladder.

Please keep in mind that your
stove's surface heats up considerably
during operation. We
recommend wearing a safety mitten
when operating your stove.

Make your children aware of this particular danger and
keep them at a distance from the heating unit whenever it is
in operation.

Attention – stove varnish is no rust prevention!

Only burn approved fuels and materials as listed in the
chapter "Clean Burning".

The burning or placing of flammable or explosive
materials, like empty spray cans, etc. into the firebox as well
as the storage of such materials in the immediate vicinity of
your heating unit is strictly forbidden due to the danger of
explosion.

Do not wear loose or flammable clothing when adding
fuel to the fire.

Placing non-heat-resistant objects on the heating unit or
in the vicinity of the heating unit is forbidden.
) [m³]
therefore
6
another hearth for solid fuels, as long as the chimney
dimensioning complies with DIN 4705, Part 3.
1350 Exhaust values for multiple use of the chimney
in accordance with DIN 4705, Part 3 and for the
400
calculation of the chimney measurements in
accordance with DIN 4705, Part 2
380
117
130
5,5 Fluegas mass flow
6 Fluegas temperature
Minimum feed pressure at Nominal
3
thermal output
65–165 Maximum feed pressure
81

Do not lay laundry onto the stove for drying. Laundry
hung up to dry must be kept at a safe distance from the
stove because of the danger of fire.

The wood stove is no slow combustion stove.

During the operation of your heating unit it is forbidden to
use flammable or explosive materials in the same or an
adjacent room to the one in which your heating unit is
located.

The appliance must only be operated with the stove and
ash drawer doors closed.

The stove and ash drawer doors must be kept closed, if
the appliance is out of use.
Setting up your stove
Required safety distances
(Minimum distances – see name plate - in Fig. 1)
a > 800 mm – towards the front in the radiated area
b > 300 mm – to the side
c > 220 mm – to the back
Make sure that the room in which the stove is set up has at
least one door or window into the outside or is directly
adjacent to such a room. Other fireplaces and extractor
hoods must not be operated in the same room as the stove.
Floor load capacity
Make sure that the load capacity of the supporting
construction is sufficient to carry the weight of the entire
unit, before the heating unit is installed.
Combustion air
The operator the stove you must take care of a sufficient
combustion air supply. Sealed-up windows and doors may
not allow a sufficient combustion air supply or disturb the
draught behaviour of your stove. Please ensure the
additional supply of fresh combustion air if necessary. For
Mr. Wu
4,2 g/s
299 °C
12 Pa
30 Pa