Connecting The Charging Station; Charging The Radios; Removing And Fitting The Belt Clip - AUDIOLINE PMR 012 Bedienungsanleitung

3.3

Connecting the charging station

Insert the plug of the power supply into the socket on the charging station
and plug the power supply into a properly installed 230 V mains socket.
For safety reasons, use only the plug-in mains power supply provided.
3.4

Charging the radios

The rechargeable battery packs for the two radios have an average
operating time of up to 10 hours when fully charged.
The current battery pack or battery capacity is shown in the display.
Full
-
To charge, place the radios in the charging station for ca. 14
hours.
-
When the radio is sitting properly in the charging station, the
charging indicator light will come on.
-
Do not leave the radios in the charging station. Continuous
charging will damage the battery pack.
If only one segment is visible, you will hear a warning tone every 10
minutes to draw your attention to the low capacity.
3.5

Removing and fitting the belt clip

To release the belt clip, push the upper tab
(1) outwards slightly with a sharp object or
screwdriver and slide the belt clip (2)
upwards.
Slide the belt clip into the guide (2) from
above until it audibly engages.
28
- Setting up -
Half Almost flat Low
1
2