Adjusting The Vox Sensitivity - AUDIOLINE PMR 012 Bedienungsanleitung

Now speak normally into the headset microphone. If the set sensitivity is
achieved, the radio will automatically start to transmit.
To switch off VOX mode, press the talk button
will remain in operation, but the talk button must be pressed in order to
speak.
Note:
Transmission will always take place for 2 seconds, even when you speak
for less than 2 seconds.
There will be a small delay before the radio starts to transmit.
4.9.3

Adjusting the VOX sensitivity

Three sensitivity levels from 1 to 3 can be set for both operating modes.
With setting 1, only loud signals will be transmitted whereas, with setting
3, softer noises will also be sent. Setting 2 is the middle, default setting.
The radios will store the last sensitivity used for each of the two operating
modes.
1. Switch the radio to the required VOX mode.
2. Press the
set will flash in the display. Also, the letter E will be displayed in
headset mode or the letter I in normal mode.
3. Select the required sensitivity between 1 and 3 using the
buttons.
4. Confirm the selection with the talk button
- Operation -
MENU
button four times. The sensitivity that is currently
once. The headset
+
.
and
35