Fitting The Belt Clip; Connecting The Charging Station; Charging The Radios; Charging The Batteries - AUDIOLINE PMR Easy 009 Bedienungsanleitung

2.3

Fitting the belt clip

After you have installed the batteries, you can fit the belt clip supplied
with the unit. Slide the belt clip into the guide from down until it audibly
engages. To remove the belt clip again, pull the fixing strap to the rear
slightly using your finger nail and push the belt clip downwards.
2.4

Connecting the charging station

Insert the plug of the power supply into the socket on the charging
station and plug the power supply into a properly installed 230 V
mains socket. For safety reasons, use only the plug-in mains power
supply provided.
2.5

Charging the radios

The rechargeable batteries for the two radios have a stand-by time of
max. 49 hours at room temperature and a maximum period of use of
up to 18 hours. The current battery capacity is shown in the display.
To charge, place the radios in the charging station for ca. 12
hours.
full
2.6

Charging the batteries

Single batteries can also be charged in the
charging station using the two battery charger
holders. If you have two battery packs with
your radio, you can charge the one battery
pack while you are using the other one in the
radio. Simply insert the two battery charger
holders in the charging station and place the
battery pack in the charging station with the
type designation facing forwards. The LED
indicator will illuminate while the battery pack
is being charged.
20
- Commissioning -
half full
batteries are
discharged.