Axkid Wolmax Bedienungsanleitung Seite 7

Route the harness straps through the shoulder pads and out through the holes in the headrest
10
to the back of the seat. Reconnect the harness straps to the yoke. Make sure the harness is
routed between the seat and the support leg.
11
Make sure the height is correct by placing your child in the seat.
Positioning The Child Restraint
The easiest way to lift the Wolmax into the vehicle is with its back first. Place the child restraint in
12
the vehicle with the back of the restraint facing the front of the vehicle.
The heels (H) should be sitting over the edge of the vehicle seat. The indented vertical line (I) on
13
the heel should align vertically with the end of the vehicle' s seat. If installing in a small vehicle, or
if your child does not require extra leg room, you can instead place the heel upon the vehicle' s
seat this will also achieve a more reclined position.
Note: When installing Wolmax in the front seat it is possible, but not crucial, for the back of the
restraint to have contact with the dashboard.
To adjust the angle of the child restraint, rotate block (G) into one of the two tilt positions. Always
14
choose the most upright position as possible, however your child must be able to hold their
head up on its own, and there should be enough recline to ensure your child' s head does not fall
forward when sleeping. The rule of thumb is that the older the child grows, the more upright the seat
can be installed. Please note that once the installation of the Wolmax is complete, it will be somewhat
more reclined as it sinks into the vehicle' s seat from tightening seat belts and tether straps.
Never install a child restraint in a passenger seat
where an active airbag is fitted.
Fastening The Vehicle Seat Belt
Open the belt lock-off clips (L) on both sides of the Wolmax child restraint. Fully lengthen the
15
seat belt until the lap section of the belt is at least 70-80cm (27-32 inches) long. Feed the seat
belt through the seat belt slot (D), between the seat cover and seat body until the belt comes
out through the seat belt slot on the other side. If you prefer, you can instead feed the seat belt through
the seat belt slot (D), then over the top of the seat belt cover and then through the seat belt slot on the
other side.
Insert the seat belt tongue into the vehicle' s seat belt buckle. Pull the seat belt until all slack is
16
removed along the seat belt route. Secure both the lap and shoulder belt in the lock-off closest
to the vehicle' s seat belt buckle.
17
In the lock-off on the opposite side, only the lap belt should be secured.
6