Safety Instructions - Stalgast 9705000 Bedienungsanleitung

Thank you for purchasing our product. Please carefully read this instruction manual before fi rst use.
Reproduction of this manual without the consent of the manufacturer is prohibited.
The photos and fi g. ings are for illustrative purposes only and may differ from the purchased device.
CAUTION: The manual should be kept in a safe place, available to the staff. The manufacturer reserves the right to change
the technical parameters of the device without prior notice.

1. SAFETY INSTRUCTIONS

• Caution! If the device was damaged during transport it should not be connected!
• Incorrect operation and improper use may result in serious damage to the device or injuries to persons.
• The device should only be used for the purpose for which it was designed.
• The manufacturer assumes no liability for any damages caused by incorrect operation and improper use of the device.
• During operation the device and the power cable plug must be protected against contact with water or other liquids. If
the device accidentally fell into water or was fl ooded with water, it is necessary to immediately pull out the plug from the
socket, and then commission the inspection of the device to an expert technician.
Failure to follow this instruction may cause life-threatening situations.
• Never open the housing of the device on your own.
• Do not insert any objects into the openings in the housing of the device.
• Do not touch the power cord plug with wet hands.
• Regularly inspect the condition of the plug and the power cord. In the event any damage to the plug or the cable is fo-
und, it should be repaired in an authorized repair point.
• In case the device falls or is damaged in any other way, before further use it is always necessary for it to be inspected and
possibly repaired at a specialized repair point.
• Never attempt to repair the device on your own - it could lead to life-threatening situations.
• It is prohibited for any changes and repairs to be performed by unauthorized persons.
• Protect the power supply cable from contact with sharp or hot objects and keep it away from open fl ames. If you want
to disconnect the device from the electrical socket, always grab it by the plug and never pull by the power cable.
• Secure the power cable to ensure that no one pulls it from the socket by mistake and that no one trips over the cable.
• Control the operation of the device during use.
• Do not allow for the device to be used by minors, people with physical or mental disabilities and people with impaired
mobility, as well as persons without the appropriate experience and knowledge regarding the proper use of the device.
Such persons can operate the device only under the supervision of a person responsible for safety.
• If the device is not currently in use or is cleaned, it is necessary to always unplug it from the power source by removing
the plug from the socket.
• CAUTION: If the plug of the power cord is connected to the electrical socket, the device remains energized.
• Switch the device off before pulling the plug from the power socket.
• The device must be well visible and easily accessible after the installation.
• It is necessary to provide easy access to the socket of a non-detachable power cable.
2. OCCUPATIONAL HEALTH & SAFETY RULES
In order to prevent burns and electric shocks caused by electric current you must respect the following safety rules:
• The staff using the device has to be instructed in terms of safe handling of the device according to the information inclu-
ded in this manual, and also has to know basic rules of use of electric devices and the safety in a workplace. In the scope
listed above you must carry the initial training for the personel handling the device out (before the fi rst start of the device
by some worker) and a periodic training.
• Do not leave the device turned on unaccompanied. Disconnect the device when it is not being used and before starting
maintenance works.
• It is inadmissible to turn off the device if any heating element and/or control element has been broken. Before starting,
you must make sure that the device is functional and that it was prepared to work according to the this manual.
• You must make sure if the power cable does not touch hot surfaces of the device and if it is not exposed to cutting.
• Pouring heating panels by water is prohibited, especially where these are warmed up. It can lead to the crack of panels
and failling water into the electric installation elements. You must avoid a situation in which the content
of pots is being poured onto the device (e.g. as a result of uncontrolled content boiling)
• During work, the device heats up - you must be careful with the possibility of burn as a result of contact
with its surface. After turning off the device, its temperature slowly decreases. Before transport or any
maintenance procedures, you must make sure that the temperature of the device decreased to a safe
level.
• During work with the device, hands of operating person have to be dry (to avoid liquid drops falling from hands to hot
heating panels) and you must use protection gloves to stripping warm pots and covers.
• You cannot clean the devices using tap water.
• Any repairs of the device can be made only by qualifi ed technical staff (technical service).
- 11 -