Keypad Functions - Storch Digi Dist Handbuch

Keypad functions

(fig. 2)
Please refer to the "Operation" section of
this manual for further information about the
following functions and calculations.
1. The "Power" button switches the device
on/off.
2. The "Read / Con" button switches on the
laser and conducts measurements; acti-
vates continuous measurement.
3. The "Arrow" button deletes the previous measurement; resets the last entry.
4. Switch between the following modes: Single distance measurement, area, volume,
single Pythagorean Theorem mode, double Pythagorean Theorem mode.
5. "Plus / Minus" button – for adding and subtracting measurements.
6. Switch the measuring reference point: Rear of the device, position of the tripod
socket, front of the device, and positioning pin (for conducting measurements from
internal corners).
7. The unit conversion button alternates between: Metres, millimetres, decimal feet,
1/16 inch increments, decimal inches and 1/16 inch increments.
8. The "Min / Max" button activates the mode for minimum or maximum measurement.
78