Replacing The Lamp; Closing The Door; Installation - Electrolux ERT1662AOW2 Benutzerinformation

Problem
If the advice does not lead to
the desired result, call the
nearest brand-mark service.

8.2 Replacing the lamp

Disconnect the plug from the mains
socket.
1. Remove the screw from the lamp
cover.
2. Remove the lamp cover (refer to the
illustration).

9. INSTALLATION

WARNING!
Refer to Safety chapters.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
Possible cause
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
There is no cold air circula‐
tion in the appliance.
3. Replace the used lamp with a new
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains
7. Open the door.
Make sure that the light comes on.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
class indicated on the rating plate of the
appliance:
Climate
class
SN
Solution
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Open the door only if nec‐
essary.
Make sure that there is
cold air circulation in the
appliance.
lamp of the same power and
specifically designed for household
appliances (the maximum power is
shown on the lamp cover).
socket.
to "Installation".
door gaskets. Contact the After Sales
Service.
Ambient temperature
+10°C to + 32°C
ENGLISH 25