Setting And Starting A Programme - Electrolux GA60GLV Benutzerinformation

16 www.electrolux.com
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
9.2 Setting and starting a
programme
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
3. Press repeatedly
shows the number of the chosen
programme. The display shows the
programme number for
approximately 3 seconds and then
shows the programme duration.
• To select the MyFavourite
programme, press
• The indicators of the options
related to the MyFavourite
programme are on.
4. Set the applicable options.
5. Close the appliance door to start the
programme.
Starting a programme with
delay start
1. Set a programme.
2. Press
shows the desired delay time (from 1
to 24 hours).
The indicator
3. Close the appliance door to start the
countdown.
During the countdown, it is possible to
increase the delay time but not to change
the programme and options.
When the countdown is completed, the
programme starts.
until the display
.
repeatedly until the display
is on.
Cancelling the delay start while
the countdown operates
When you cancel the delay start you
have to set the programme and options
again.
Press and hold simultaneously
until the appliance is in programme
selection mode.
Cancelling the programme
Press and hold simultaneously
until the appliance is in programme
selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme ends. It
does not happen if the door
is opened by AirDry function.
End of the programme
When the programme is completed the
display shows 0:00.
All buttons are inactive except for the
on/off button.
1. Press the on/off button or wait for the
Auto Off function to automatically
deactivate the appliance.
If you open the door before the
activation of Auto Off, the appliance
is automatically deactivated.
2. Close the water tap.
and
and