Herunterladen Inhalt Inhalt Diese Seite drucken

Apply Decals / Anwenden Von Decals - Ripmax NANO Boomerang Bauanleitung

Inhaltsverzeichnis

Werbung

Apply Decals / Anwenden von Decals

You are now ready to apply the supplied decals. One at a time,
carefully remove the decals from their backing sheet, apply to
the model and gently smooth down.
Entfernen Sie die Aufkleber nacheinander vorsichtig von der
Trägerfolie und bringen Sie diese an den gewünschten
Stellen an.
Balancing / Schwer punkt
The balance point of the Nano is 140 to 150mm (5 1/2" to 5 3/4")
back from the leading edge at the root of the centre wing panel,
this should be measured with the undercarriage extended and
with any header tank (if used) full.
Der Schwerpunkt des Nano sollte 140 bis 150mm hinter der
Flächen-Vorderkante (am Flächenmittelteil) liegen. Dies sollte
mit ausgefahrenem Fahrwerk und gefülltem Tank ermittelt
werden.
INSTRUCTIONS / ANLEITUNG
140-150mm
27
140-150mm
(51/2 -5.75˝

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis