Lenz GOLD Decoder Information Seite 39

Example 2: You wish to read out the present value of CV902 of the S.U.S.I. module:
3. Enter 902-800=102 in the indicator CV126.
4. Read out the transport device CV127. The value of CV902 of the connected module is
displayed.
5.12 USP - Uninterruptable Signal Processing
In combination with the optional energy storage, the intelligent USP circuit ensures that your
locomotive can run even over dirty track sections or dead frogs. The energy storage is not included
with this decoder and is installed separately in the vehicle.
Soldering surfaces are provided on the decoder for the connection of the energy storage (e.g.
Power 1), see Abb. 4, p. 6. Solder the respective cable of your energy storage to the soldering
surfaces. Make sure that you do not create short circuits to other soldering surfaces or between
soldering surfaces.
5.13 RailCom
The GOLD decoder is equipped with the RailCom function. In addition to the locomotive address,
other data (e.g. speed, CV content) can be transmitted from the locomotive via the track back to the
system. The information sent is received by a RailCom detector and then displayed. Which data
the decoder is to send is set in CV28. Set Bit 4 in CV29 to enable the transmission function.
39
E