Rage - Specification; Tightening Torque; Suspension - Propain Rage Bedienungsanleitung

11
Rage – specification
PROPAIN's Rage is a Downhill Bike. Please find the according cat-
egory in the "user handbook bicycles" which is included in your bike
delivery. Be sure to use your bicycle only according to the "intended
use" specified by the category.
If you replace parts of your bicycle, please pay special attention to
the hardware compatibility. If in doubt, please contact Propain or
your local bike dealer.
The Rage has the following specifications:
Maximum front travel allowed:
Rear travel:
Shock length:
Shock travel:
Shock mount top and bottom (both sides):
Bottom bracket:
Break mount:
Seat post diameter:
Headset (S.H.I.S.):
203mm
220mm
241mm
76mm
22,2mm x 8mm
83mm BSA
Post Mount 160
31,6mm
Tapered: Top: ZS44 /
Bottom: ZS56
Rear wheel axle:
Rear hub width:
Chain line:
Chain guide mount:
Recommended tire size:

Tightening torque

The mounting bolts of the frame and suspension have to be tight-
ened according to the table below. After untightening any bolts
Propain recommends using Loctite 243 (medium) before tightening
the bolts again. Please also consider the drying time of Loctite.

Suspension

Bearing
1)
2)
3)
4)
157mm Syntace X12
157mm
56,5mm
ISCG05
650B (27,5")
Tightening torque
25 Nm / 18,44 ft lb
25 Nm / 18,44 ft lb
9 Nm / 6,64 ft lb
9 Nm / 6,64 ft lb