Herunterladen Diese Seite drucken

Ruby Fires RC02 - 0004 - VARESE Gebrauchsanleitung Seite 11

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Make sure that the specifications on the rating plate correspond to the situation in your
household. This appliance should only be connected to a properly earthed power outlet.
Unplug the appliance from the mains during thunderstorms or if you will not be
using it for a long period. Always grasp the plug itself, not the cable. Make sure your
hands are dry before touching the mains plug.
Never use the appliance outdoors or in rooms with high humidity, e.g. in bathrooms.
Do not use the appliance close to water. Proximity to water is a risk even if the
appliance is switched off.
Do not insert any objects into the openings on the appliance.
Troubleshooting
In the interests of your own safety, check the appliance for damage before every use.
If the appliance is faulty, it must not be used until it has been repaired by an expert.
If the appliance has fallen or been dropped, there may be damage to internal
parts that is not detectable from the outside. For this reason the appliance must be
checked by a specialist before it can be used again.
In the event of damage/malfunction, unplug the appliance immediately.
Do not use the appliance if the power cord, plug or any part of the appliance is damaged.
Operation
The appliance gets warm during operation, especially at the bottom.
Objects situated below the appliance can also get warm. Do not touch the warm
surfaces. Keep children away from the hot surfaces.
If you hear unusual noises from the fan or notice unusual smells, if liquids or
small objects have found their way into the appliance, or if other malfunctions
occur, unplug the appliance from the mains immediately and have it checked by a
specialist repair shop.
Installation
The electric fireplace must be installed on a wall at a high of 1m above the floor. Nail the
accessories such as the bolts in the all and put up the electric fireplace. The illustration as
following,
The heater must not be located immediately above a socket-outlet.
Do not run the cord on carpeting and do not cover the cord with any things.
The heater must be located in such a way that the socket-outlet stays in reach.
CAUTION!

Werbung

loading