Herunterladen Inhalt Inhalt Diese Seite drucken

Replacing The Lamp; Noises; Closing The Door - AEG SCE81921TS Benutzerinformation

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Problem
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

9. NOISES

There are some sounds during normal running (compressor, refrigerant circulation).
OK
Possible cause
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The "Frostmatic function"
or "Coolmatic function" is
switched on.
There is no cold air circula-
tion in the appliance.

8.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
HISSS!
ENGLISH
Solution
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Add less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "Frostmatic function"
or "Coolmatic function".
Make sure that there is cold air
circulation in the appliance.
BRRR
15
!

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis