Technical Information; Technical Data - Electrolux ERT1606AOW Benutzerinformation

10. Tighten the hinge.
11. Put the top in position.
12. Push front the top.
13. Screw both screws on the rear side.
14. Remove and install the handle on the
opposite side.

10. TECHNICAL INFORMATION

10.1 Technical data

Height
Width
Depth
Voltage
Frequency
1
CAUTION!
Reposition, level the
appliance, wait for at least
four hours and then connect
it to the power socket.
9.6 Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
2
domestic power supply socket is not
3
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
mm
mm
mm
Volts
Hz
Do a final check to make sure
that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature is
cold (i.e. in Winter), the
gasket may not fit perfectly to
the cabinet. In that case, wait
for the natural fitting of the
gasket. In case you do not
want to carry out the above
mentioned operations,
contact the nearest After
Sales Service Force. The
After Sales Service specialist
will carry out the reversibility
of the doors at your cost.
850
550
612
230 - 240
50
ENGLISH 27