Rear Spacers - Electrolux ERT1606AOW Benutzerinformation

Climate Ambient temperature
class
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems
might occur for some types
of models when operating
outside of that range. The
correct operation can only be
guaranteed within the
specified temperature range.
If you have any doubts
regarding where to install the
appliance, please turn to the
vendor, to our customer
service or to the nearest
Service Centre

9.2 Rear spacers

You can find the two spacers in the bag
with documentation.
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
4
9.3 Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.
2
1
3
If you place the appliance on a stand:
1. Unscrew the foot of the door hinge.
2. Screw the spare foot, found in the bag
with the egg tray, into the cabinet.
9.4 Location
It must be possible to
disconnect the appliance
from the mains power supply;
the plug must therefore be
easily accessible after
installation.
The appliance should be installed well
away from sources of heat such as
radiators, boilers, direct sunlight etc.
Ensure that air can circulate freely around
the back of the cabinet. To ensure best
performance, if the appliance is positioned
below an overhanging wall unit, the
minimum distance between the top of the
cabinet and the wall unit must be at least
100 mm . Ideally, however, the appliance
should not be positioned below
overhanging wall units. Accurate levelling
is ensured by one or more adjustable feet
at the base of the cabinet.
100 mm
15 mm
ENGLISH 25
15 mm