Epson TM-J7000 Bedienungsanleitung Seite 20

English
Note:
Be sure not to use an adhesive cleaning sheet.
Follow the steps below:
1. Load roll paper in the printer; turn off the power; then open the
roll paper cover and turn the power back on while holding
down the CLEANING button.
2. Press the CLEANING button 7 times; then close the paper roll
cover. The printer prints the following message on the roll
paper and the CUT SHEET LED flashes.
3. Insert the cleaning sheet like a standard check.
CAUTION:
Be sure that the sheet is inserted with the correct side up and that it is
inserted in the correct direction.
Use a cleaning sheet only one time; then discard it.
Notes on using the MICR reader
Do not install the printer near any magnetic fields. Be especially
careful where you install your display device and be sure to check
the recognition rate of the MICR reader with the display device in
place.
Make sure that the printer is not subjected to any impact or
vibration when it is performing a MICR reading.
12 TM-J7000/J7100 User's Manual
**** RECOGNITION MODE
Please set check.
****