Epson TM-J7000 Bedienungsanleitung Seite 14

English
CLEANING
If printing becomes faint or uneven and the INK OUT LED is not on
or flashing, use this button to clean the print head. Press the button
until the printer mechanism begins to clean the print head (more
than 3 seconds). When the cleaning stops, the printer is ready for
normal printing.
Note:
Do not use the CLEANING button unless there is a problem with print
quality. Unnecessary cleaning will waste ink.
Power Switch and Power Switch Cover
The power switch is on the front of the printer. Press the power
switch to turn on the printer.
To maintain print quality (by capping the print head), be sure to
follow these instructions for turning off the power: Wait at least
8 seconds after printing on roll paper or after removing a cut sheet;
then turn off the power switch.
Note:
Never open the printer cover or turn off the printer when the POWER
LED is flashing.
Power Switch Cover
You can use the enclosed power switch cover to make sure that the
power switch is not accidentally pressed. Just press the cover into
place to install it. If you need to turn the power switch on or off
with the cover attached, you can insert a thin tool into one of the
holes in the cover to operate the switch. See illustration C.
WARNING:
If an accident occurs when the power switch cover is attached,
immediately unplug the power supply cable to avoid fire.
If you are going to store the printer or leave it unused for a long
time, turn it off using the power switch on the printer.
6 TM-J7000/J7100 User's Manual