Caller Id; Mode Preset Buttons; Mode Recall; Automatic Power-Off - Motorola MCS 2000 II Bedienungsanleitung

English
MCS 2000 Models II & III
Keypad Selection:
(model III or model II with optional keypad micro-
phone)
Press the call button (12) or select PRIVATE CALL
through the menus and enter the desired ID directly
from the keypad.
If an incorrect number is entered the digits may be
erased by using the mode selector (D) to the left/
down. Continue using the mode (D) to the left/down to
erase the entire ID. Then enter the correct ID.
When the ID has been selected in one of the two ways
described above, the private call may be transmitted
to the displayed ID by pressing the PTT (F).
Enhanced Private Call
If an Enhanced Private Call is not answered within 20
seconds the display changes into
model III
NO ANSWER
ID: 700001
Press the PTT (F) to leave your ID with the called radio
so that you will be called back later. The call alert sent
tone will sound.
model II
NO ANSWER

Caller ID

The radio will momentarily display the ID or alias name
of the radio that initiated a call. If an emergency call is
received in trunked operation, the radio will alternate
the display between the talkgroup, the emergency
received display and the ID (or alias name) of the radio
that initiated the emergency call.

Mode Preset Buttons

Mode preset buttons will allow quick access to com-
monly used modes. Press and hold a mode preset
button until a good-key tone is heard to program the
button for the currently selected mode. A short press
of a mode preset button will cause the radio to imme-
diately change to the mode programmed for that but-
ton.

Mode Recall

The radio will always remember the last mode
selected. Pressing mode recall will cause the radio to
switch to the previously selected mode.
Note: The "last" mode must be selected for a mini-
mum of 5 seconds to be retained as the "last" mode.

Automatic Power-Off

"Automatic power off" will power off your radio when
page 10
68P81083C10-C