Cleaning The Hood - De Dietrich DHD7261B Installationsanleitung

3
•

CLEANING THE HOOD

Careful maintenance ensures proper
operation and good performances over
time.
MAINTENANCE
External surface
and accessories
Grease filter with
extractable unit
open
Activated charcoal
filter
HOW TO PROCEED?
Do not use metallic scrub-
bers, abrasive products, or
hard brushes.
After 30 hours of operation,
the downdraft will signal the
grease filter saturation.
The saturation is signaled by
the flashing of the 4 central
leds. To reset, press the ti-
mer key .
In the filtering version, the acti-
vated charcoal filter shall be re-
placed regularly. To remove the
charcoal filter panel, first of all it
is necessary to remove the gre-
ase filter grid and then pull the
plastic key of the panel itself,
in order to disengage it from its
seating. Follow these steps in
reverse order to fit the activated
charcoal filter. Replace the used
charcoal filter on an average of
every six months.
The hood shall be disconnected
from the electrical network ,by both
unplugging the appliance from the
socket and activating the magnetic
circuit breaker (safety cut-out), befo-
re removing the metal grease filters.
After cleaning operations, refit the
metal grease filters as detailed in the
installation instructions.
PRODUCTS /ACCESSORIES
To clean the external surfa-
ce of the hood and the light
housing screen use only
commercially available hou-
sehold detergents diluted in
water. Then rinse with cle-
an water and dry with a soft
cloth.
Grease filters can be washed
by hand or in the dishwasher.
These filters need to be cle-
aned on a regular basis,
otherwise they may repre-
sent a fire risk.
Refit the grease filters and
the front panel, making sure
that the panel is properly fit
on both sides so that it does
not cause the downdraft to
stop operation.
41
TO USE