Insert/Remove Battery; Charge Battery - Grizzly ARM 4038 Lion-Set Originalbetriebsanleitung

ARM 4051 A Lion-Set
- Battery scarifier
ARV 4038 Lion-Set
Do not expose the battery to ex-
treme conditions such as heat
or impact. Risk of injury from
escaping electrolytic solution!
After eye/skin contact, rinse the
affected areas with water or a
neutraliser and consult a doc-
tor.
Charge the battery in a dry
room only. Prior to attaching
the charger, check that the
battery's outer surface is clean
and dry. There is a risk of injury
due to electric shock.
Only use the charger from the pa-
ckage to charge the battery.
• Charge the battery before the first
time of use. Do not briefly charge the
battery several time in a row.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
A B C D
K L M N

Insert/remove battery

U V W X
Switch off the device, pull the con-
tact chip (
blades to come to a stop. There is
a risk of personal injury.
1. To insert the battery (7) into the
2. To remove the battery (7) from

Charge battery

Allow a freshly charged battery
(7) to cool down for approx. 15
minutes before inserting it into the
battery charger (11).
1. Remove the battery (7) from the
2. Insert the battery (7) in the
3. Plug the battery charger (11)
4. When the battery is fully rechar-
5. Press the release button (
E F G H
O P Q R
Y Z
17) and wait for the
device, push the battery along
the guide rail into the device. It
locks into place audibly.
the device, press the release
button ( 7b) on the battery
and pull the battery out.
appliance, as necessary.
charging compartment of the
battery charger (11). It will au-
dibly snap in.
into a mains outlet. The charg-
ing indicator lights up:
green LED flashes, red LED
lights up: Battery charging
green LED lights up:
Battery is charged
ged unplug the battery charger
(11) from the mains.
7b) on the battery (7) and pull
the battery out of the battery
charger (11).
GB
I J
S T
35