Trouble Shooting - Grizzly ARM 4038 Lion-Set Originalbetriebsanleitung

Trouble Shooting

Problem
Equipment does not
start
Motor stops
Result unsatisfactory or
motor labours
Messer rotiert nicht
Strange noises, rattling
or vibrations
Possible Cause
Battery ( 7) is empty or
not inserted
Contact chip
( 17) not inserted
Defective start lever (
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign object
Cut height too low
Blade blunt
Blade area blocked
Blade assembled incorrectly Install the blade correctly
Blade blocked by grass
Blade screw loose
Blade screw loose
Blade damaged
Fault Fixing
Check charge level,have re-
pairs carried out by a qualified
electrician, if necessary
Insert the contact chip
17)
Repair by customer services
Set a greater cut heigh
Lift the front wheels slightly by
pressing down on the handle
bar.
Remove the foreign object
Set a higher cut height
Have the blade sharpened or
replace it
Clean the equipment
Remove the grass
Tighten the blade screw
Tighten the blade screw
Replace the blade
GB
.
41