Assembling Instructions; Install Lower Bar; Install Curved Handle; Installing The Grass Box - Grizzly ARM 4038 Lion-Set Originalbetriebsanleitung

GB
7 Rechargeable battery
7a Battery Indicator
7b Locking button
8 Cutting height adjuster
9 Front wheels
10 Housing
11 Battery charger
11a Display Battery charger
12 Back wheels
13 Collection bag
14 Rear impact protection
15 Cable holder
16 Connection cable l
17 On/Off button / Contact chip
18 Safety switch
19 Battery Indicator
20 Locknut
21 Blade

Assembling instructions

• Alwayas wear cut-protection gloves
• Undertake only work with which you
are confident.
• In case of uncertainty, contact a speci-
alist or contact our service directly

Install lower bar

1. Open the lower bar (4) and move
it to the desired inclination.
2. Fix the lower bar by means of
the pre-mounted quick-release
levers (5).

Install curved handle

1. Fasten the curved handle (1)
with the nuts, the washers and
the upper tightening levers (2)
to the right and left of the lower
bar (4).
32
2. Clipping in the cable holders:
Clip the cable holders
(15 ) onto the lower bar to fi-
xate the machine cable (16
If you loosen the quick release
levers, you can fold down the
curved handle and the lower part
of the handle for storage of the de-
vice.

Installing the grass box

The collection box is already completely
preassembled.
1. Insert the strap (13b) of the
grass catcher (13) into the notch
provided on the rear side of the
lid (13a). Fix it with washers and
screws.
2. Insert the lower part (13c) into
the recesses provided on the
upper grass catcher (13a). Fix
it by pushing the tabs over the
strap and snapping the plastic
strip into the upper recesses of
the lid.
Attention: Do not operate the
appliance until the collision
guard and grass box are fully
installed. Risk of injury!

Initial Operation

Before operating the machine,you must
- install the upper and lower upper
handles:
- install the collection bag
Caution! Risk of injury! During
the assembly or disassembly of
).