Indicator Charge Level; Insert/Remove Battery; Charge Battery; Used Batteries - Grizzly BRM 56-163 BSA Quattro Originalbetriebsanleitung

UK
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.

Indicator charge level

The number of illuminated LED
lights shows the charge level of the
battery.
4 lights means battery is fully char-
ged.
1 light means that the battery
needs to be charged.

Insert/remove battery

1. To insert the battery (25) into
the device, push the battery
along the guide rail into the de-
vice. It locks into place audibly.
2. To remove the battery (25) from
the device, press the release
button (30) on the battery and
pull the battery out.

Charge battery

Allow a freshly discharged battery
(25) to cool down for approx. 15
minutes before inserting it into the
battery charger (26).
I
1. Remove the battery (25) from
the appliance, as necessary.
2. Insert the battery (25) in the
charging compartment of the
battery charger (26). It will au-
dibly snap in.
98
3. Plug the battery charger (26)
into a mains outlet.
4. When the battery is fully rechar-
ged unplug the battery charger
(26) from the mains.
5. Press the release button (30) on
the battery (25) and pull the bat-
tery out of the battery charger
(26).

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").
Filling with Engine Oil and
Checking the Oil Level
Place the equipment on a level
base.
1. Unscrew the oil filler cap and dipstick
( 7) and pour oil into the tank. The
oil tank holds 0.47 l oil. Use brand oil
(e.g. SAE 30).
2. To check the oil level, wipe the dip-
stick on a clean cloth and replace it in
the tank until it stops.
3. After pulling it out, read off the
oil level on the dipstick. The oil
level should be in the marked
area between the minimum and
maximum marks.
4. Wipe off any spilt oil and close
the oil filler cap ( 7).