Beem i-Joy Cafe 15 bar Bedienungsanleitung Seite 30

26 EN
NOTE
► Remove any surplus coffee powder
from the edge of the strainer holder in
order not to stain the seal of the strainer
holder mounting (18).
► Do not overfill the strainer insert. An
overfilled strainer insert cannot be inserted
into the appliance.
Brewing 1 large cup of cappuccino
To brew a large cup of cappuccino, proceed
as follows:
1. Prepare the appliance as described
above.
2. Remove the strainer holder (15) and put
in the higher strainer insert (11).
3. Fill with coffee as described above and
insert the strainer holder into the appliance.
4. Push the large drip tray (16) under the
milk container (5).
5. Place a large cup onto the small drip tray
(17).
6. Press the selector button
2 x. The process finishes automatically or
when the selector switch (13) is pressed
briefly to cancel brewing.
7. Use the ON/OFF switch (4) to switch the
appliance off.
Brewing extra froth and warm
milk (Latte)
To prepare milk froth and warm milk for co-
coa, you require :
1. a suitable cup,
2. refrigerated milk with at least 2 % fat.
Preparation:
1. Check the drip trays (16, 17) and empty if
necessary.
2. Check the water level in the water tank
(3) and add water, if necessary. The water is
required for the generation of steam.
3. Fill the milk container (5) with milk and
put it into the appliance properly.
4. Switch on the appliance and allow it to
heat up.
5. Use the operating lever (8) only to point
the steam nozzle (6) of the appliance to the
cup (image F1) .
6. Turn the milk froth regulator (7) right to
cappuccino for more milk froth or left to latte
macchiato for less milk froth.
7. Press and hold down the selector button
(13) for at least 3 seconds until indicator
lamps 12 and 14 extinguish. Milk frothing
starts.
8. The process finishes automatically or
when the selector switch
briefly to cancel brewing.
9. Pull out the froth container downwards.
10. Tap the froth container once or twice on
a firm surface to condense the frothed milk
produced.
11. Pour or skim the frothed milk into the
drinking receptacle.
12. Switch off the appliance with the ON/OFF
switch (4) and allow it cool down.
13. Clean the steam nozzle and the metal
tube immediately after use to prevent depos-
its and clogging of the steam nozzle.
Instructions on cleaning can be found in
the section Cleaning the steam noz-
zle (page 28).
(13)
Brewing 1 glass of latte macchiato
To make latte macchiato, proceed as follows:
1. Check the drip trays (16, 17) and empty if
necessary.
2. Check the water level in the water tank
(3) and add water, if necessary.
3. Fill the milk container (5) with milk and
put it into the appliance properly.
4. Switch on the appliance and allow it to
heat up.
5. Remove the strainer holder (15) and put
in the strainer insert (10).
6. Fill the strainer insert (10) with coffee
powder to the top and wipe off any excess
coffee powder with the handle of the measur-
ing spoon (9).
7. Press the coffee powder lightly but firmly
using the compacting aid of the measuring
spoon (9).
BEEM - Elements of Lifestyle
Brewing latte macchiato
(13) is pressed