Christopeit Sport Como Bedienungsanleitung Seite 18

Step 4:
Attach the rear foot (24) and foot pedals (34).
1. Put the rear foot (24) into the holder at seat rail (6) and screw
it tightly by using screw M10x110 (22), screw M8x45 (23),
washers (5) and self locking nut (10).
2. Screw into below threats at main frame the screws M12x170
(33). Then attach the foot pedals (34) at main frame (1) into ap-
propriate position in upper threats with screws M12x170 (33).
Step 5:
Attach the computer (38) at computer support (48).
1. Push the connecting cable (49) and sensor connection cable
(37) through the computer holder (44) into front position.
2. Put the computer holder (44) with two plastic washers (42+43)
onto the computer support (48) and attach it with carriage bolt
M8x75 (39), washer (5) and nut (31).
3. Remove the 4 screws (51) from backside of computer (38).
Lead the computer (38) to computer holder (44) and push the
plug of the connecting cable (49) and sensor connection cable
(37) into the associated socket of the computer (38).
4. Storage the cable connection into the backside of computer
(38) and put the computer (38) on the computer holder (44) and
attach it with the screws (51).
Note: If the set position of computer change automatically du-
ring exercising, then tighten the nut (31) a little bit at the com-
puter support (44) for a fixed incline position, as well as the nut
(31) behind the plug (53) for computer height position.
18