Back To Home Position & Turning Off - SELFSAT SNIPE 2 Bedienungsanleitung

2. Selecting the satellite
a. Select the satellite which user wants to view using arrow buttons on the controller and press OK.
b. Network Identification (NID) check LED will flash and the antenna status will display "SEARCHING" and
then "CHECKING" on LCD screen.
c. NID check LED will be solid once the satellite is found and then "SAT FOUND" will appear on LCD.
d. If wrong satellite is selected, move to the correct satellite name using arrows and press OK to confirm
new satellite.
3. Back to HOME position & Turning off
a. After use and before travelling, press HOME to return the unit back to HOME position.
b. To fully turn off the unit, press and hold POWER for 5 seconds when the unit is at HOME position.
c. If user stays in a location for an extended period or wish to save power, user can leave the unit up by
simply turning off the unit. Signal will still come through to satellite TV receiver.
4. Special function 1 : FINE TUNE mode
FINE TUNE mode can be initialized when a selected satellite is found and user wants to increase the signal
strength further.
a. Press TUNE to start FINE TUNE mode.
b. First TUNE is for AZ (Azimuth). Adjust antenna position using arrow buttons to find a new position
providing better signal quality and press OK to set. The signal level will be displayed on the controller
(Q ___ ) or satellite receiver.
c. Repeat the same process of adjust the EL (Elevation) and SK (LNB skew).
d. To save new position of the satellite and exit, press TUNE button. Saved new position will be placed
in the memory for the next turn on. But once vehicle moves or confirms new GPS location, the saved
position will be reset.
ENGLISH - 8