Technical Specification - QED MusiQ RFS System Bedienungsanleitung

5 TECHNICAL SPECIFICATION

Power Output into 5 Ohms @ 1 kHz
Power Output into 5 Ohms @ 1 kHz
Recommended Speaker Impedance:
Frequency Response:
Frequency Response of
Active EQ Sound Enhancement:
Distortion THD
(measured into 5 Ohms)
Channel Separation:
Input Sensitivity:
5.1 Microphone Input
Input Impedance:
Gain Control Range:
Frequency Response:
5.2 General
Weight:
Power Consumption:
Battery
(MusiQ RF/RFS Handset only)
Supported Brands
6 OPERATION
6.1 MUSIQ FRONT PANEL CONTROLS (RFS MODELS)
Two columns of buttons on the front panels of the RFS models enable control of both Zones directly from the unit. The
left hand buttons control the functions of Zone A and the right hand buttons control the functions of Zone B.
1. Pressing the Source 1 (tuner) or Source 2 (CD) button when the unit is in Standby will turn the zone ON and select
the appropriate source. The volume will increase to a low listening level (see note below), and both the display and
buttons will illuminate.
2. Pressing the Standby button will return the zone to standby. If both zones are active and one is switched into standby
the other zone will remain ON. The display will remain active until both zones are in standby.
Note: When either Zone is returned to standby the Volume level is remembered, providing the unit is not switched
OFF.
This means that the volume will return to the previous listening level when the zone is re-activated on
subsequent occasions.
3. Pressing the Volume Up button will increase the listening level in the zone. The LCD volume bar graph display rises
to indicate the level reached.
4. Pressing the Volume Down button will decrease the listening level in the zone. The LCD volume bar graph display
falls to indicate the level reached.
16
MusiQ User Instructions
Technical Specification, Operation
22 W at 0.1%THD
20 W at 1.0%THD
4 - 16 Ohms
20 Hz to 20 kHz ±0.5dB
+2.75 dB @ 100 Hz relative to 0 dB at 1 kHz
+0.55 dB @ 5.3 kHz relative to 0 dB at 1 kHz
1 kHz at 10 W <0.04%
>80 dB @1 kHz between Left & Right Channels.
>90 dB @1 kHz between Source 1 & Source 2 Inputs.
370 mV RMS into 100k Ohms for full output at maximum volume
680 Ohms
45 dB
40 Hz to 20 kHz ±0.8dB
3.5 kg
120 W
Type MN21, GP23A or VR22
RC-5 - A Philips code set used by many other companies including
Arcam, Linn and Marantz
Caution: Some manufacturers who claim to use this code set do not follow the correct
protocol and therefore their equipment may not respond correctly, or at all.
Denon
Check with dealer first.
Pioneer, Sony, Yamaha
One channel driven.
Two channels driven.
One channel driven
(suitable for microphones with a nominal impedance of 200-1k Ohms)
(Available from all good photography shops)
Caution: MusiQ will operate tuners with direct preset selection only.