Installation; Connection Cable; Before The Installation; Built-In Hobs - AEG HKH81700FB Benutzerhandbuch

18 www.aeg.com
Problem
E4 comes on.
E7 comes on.
E8 comes on.
E9 comes on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass

8. INSTALLATION

WARNING!
Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down
the information bellow from the rating
plate. The rating plate is on the bottom
of the hob.
Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you
assemble the hob into correct built-in
Possible cause
There is and error in the hob
because a cookware boils
dry. Overheating protection
for the zones operates.
The cooling fan is blocked.
The electrical connection is
incorrect. The hob is con-
nected only to one phase.
There is an error of the inter-
face.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
units and work surfaces that align to the
standards.

8.3 Connection cable

• The hob is supplied with a connection
cable.
• To replace the damaged mains cable
use the following (or higher) mains
cable type: H05BB-F T min 90°C.
Speak to your local Service Centre.
Remedy
Deactivate the hob and let it
cool down. Activate the hob
again. If the cookware was
the problem the message
goes out. If the message
comes on contact an Author-
ised Service Centre.
Check if objects block the
cooling fan. If the message
comes on again contact an
Authorised Service Centre.
Speak to a qualified electri-
cian to check the installation.
Refer to the connection dia-
gram.
Deactivate the hob and acti-
vate it again. If the message
comes on contact an Author-
ised Service Centre.