Troubleshooting - AEG HKH81700FB Benutzerhandbuch

16 www.aeg.com
• Remove when the hob is sufficiently
cool: limescale rings, water rings, fat
stains, shiny metallic discoloration.
Clean the hob with a moist cloth and
some detergent. After cleaning, rub
the hob dry with a soft cloth.
• The surface of the hob has horizontal
grooves. Clean the hob with a moist

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate or oper-
ate the hob.
The hob deactivates.
There is no pot indication on
the flexible zone.
Power Boost is not activating
for the pot on the flexible
zone.
cloth and some detergent with
smooth movement from left to right.
After cleaning, rub the hob dry with a
soft cloth from left to right.
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is released.
There is water or fat stains
on the control panel.
You put something on the
sensor field .
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
There is already cookware
on the zone.
The pot is bigger than 240
mm. The maximum power is
reached.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec-
tion diagram.
Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Clean the control panel.
Remove the object from the
sensor field.
Use the correct cookware.
Refer to "Hints and tips"
chapter.
Use cookware with correct
dimensions.
Refer to "Technical informa-
tion" chapter.
Move the first pot slightly to
make room for the next one.
It is normal for this size of
pot. Use smaller pot or use
the highest heat setting for
the big one.