Quick Setup - Velleman CU2200 Bedienungsanleitung

LED 1 – green status LED
Rapid flashing on/off
GSM module normal operation
Flashing on/off
GSM network connection problem
Reason:
Antenna not connected
No SIM card
Defective SIM card
Defective GSM module
Sound Monitoring
The CU2200 automatically picks up any phone call after eight rings. By connecting a microphone to the
CU2200, you will be able to hear all actions in the room.

7. Quick Setup

8. PC Setup Software [V7.0]
The unit can be programmed by:
First check the hardware version of your device via an SMS from your mobile phone. When the SMS was correct
the device will reply with a text message containing the version; if there was an error you will get the message
'SMS format is error!'. The SMS command depends on the software version:
Software version V5, V6
Command: PWD:XXXX,CHECKV
[SMS message received]
ex: SD41 V5.1_3_B 2008/01/28
V5 is system version or hardware version

CU2200.
Important notes on used PC Software:
 Software can be found on the included CR ROM or on the product page on www.velleman.eu.
 Software version SMS_ProX.exe (SMS PRO_V5.0) only works with hardware version 5 of the CU2200.
 Software version SM41DPRO.exe (SMS PRO_7.0) works with both hardware versions 6 and 7. It is
recommended to use this version when you have a hardware version 6 or 7 device.
 Software version SMSPro_Setup_2.2.13_0927.exe only works with hardware version 7. When running
this software, select "basic" at start-up.
 The software is developed for multiple platforms; hence it is possible that some of the shown functions
are not accessible or (fully) supported.
Note: it is not possible to upgrade the hardware version of the CU2200.
 Copy the program folder to C:\ ,and run "SM41DPRO.exe" under windows.
23.10.2014
CU2200
LED 2 – red network LED
On
Flashing on/off
 Press the yellow button so as to eject the card caddy. Insert
the SIM card with the contacts facing down. Press the card
back into the CU2200.
Attention: "asking for PIN code" must be deactivated
on SIM card first, before use with CU2200! (See
instructions of your mobile phone).
 Connect the 12VDC power supply and wait until the red LED
turns on and the green LED flashes every few seconds.
 Send following SMS message to the CU2200 (from another
mobile phone): PWD:1234,STATUS%.
 Your mobile phone will receive an SMS reply within 30
seconds reporting the health status.
NOTE: The SIM card in the CU2200 must be activated by a
provider like a regular SIM card in a mobile phone.
Make sure to activate the caller ID service.
(A) SMS command via mobile phone
(B) Software via its built-in RS232 port
Software version V7
Command: PWD:XXXX,CHECKVR%
[SMS message received]
ex: SD41 V7.1_3_B 2010/01/28

4
Normal operation
Searching GSM network
Connecting to network
Receiving SMS messages
Sending SMS messages
Phone dialling
V7 is system version or hardware version
CU2200.
v
3-03
©Velleman nv