Dismantling And Disposal; Warranty And Customer Service; Connection Diagram - G-U ELTRAL K60-300N 24V Bedienungsanleitung

2.10 Dismantling and disposal

Dismantling
Danger!
Observe the safety instructions!
Caution!
For dismantling the appliance proceed as described under "Installation", however, in reverse order.
Settings are irrelevant.
Disposal
Motor components
•
Aluminium
⇐ •
Iron
•
Plastic
Note!
•
Copper
•
Zinc
Dispose of the parts in accordance with the local disposal regulations.

2.11 Warranty and customer service

Our "General Terms of Business" apply in principle.
The warranty complies with legal regulations and is valid in the country where the motor was
purchased.
The warranty covers material and manufacturing defects occurring under normal stress.
Warranty and liability claims in view of personal injury and damage to property are excluded, if the
latter have occurred as a result of
Inappropriate use of the motor
Improper installation, commissioning, operation, maintenance and repair of the motor
Operation of the motor with faulty, incorrectly fitted or non-functional safety and protection de-
vices
Failure to observe the instructions in the Installation and Operating Guide
Unauthorised structural modification of the motor
Catastrophic events due to penetration of foreign bodies and force majeure.
Wear
For possible warranty claims or the delivery of spare parts or accessories, please contact your re-
sponsible distribution company.

2.12 Connection diagram

Connection of K60-300N
The connecting cable of the drive is approx 5 m long. If the distance between drive and wall switch is
longer, the cable must be extended. (see section 2.5 „Installation (electrical)").
The connection is to be carried out according to the following wiring diagram.
Drives preset for tandem- / tridem-operation are supplied as set and may be installed as
master and slave set only.
With the programmed synchronisation of two or three drives, each drive must be mounted
and connected as specified on the programming label on the drive,.
e.g. with programmed tandem operation:
Drive set 1 drive 1 / Master
Caution!
Drive set 1 drive 2 / Slave
with programmed tridem operation:
Drive / Master
Drive 2 / Slave 1
Drive 3 / Slave 2
The integration of the drive(s) into a closing sequence control system ist possible with locking
drive ELTRAL VA25 or ELTRAL VA35 (for assembly and electrical connection see the locking
drive mounting instructions)
Caution!
25 26