Sony SU-WL51 Gebrauchsanweisung Seite 8

Step 4:
Preparing for the
installation of the
TV or monitor
The procedure differs depending on
the TV or monitor. Apply the
procedure appropriate for the TV or
monitor you are installing.
KDL-40S2000/KDL-40S2010................... A
KLV-40U100M .......................................... B
If you intend to install a TV or monitor that is not specified
on above, be sure to refer to the leaflet "Installing the Wall-
Mount Bracket" supplied with your TV or monitor.
1
Remove the screws from the rear
side of the TV or monitor.
A
B
Remove the eight screws from these
eight holes in the rear side of the
monitor.
8
(GB)
2
Detach the Table-Top Stand from
the TV or monitor.
A
B
3
Attach the supplied four hooks
on the rear side of the TV or
monitor.
Place the TV or monitor with its screen facing down on
a stable cloth-covered work surface.
Attach the supplied four hooks with the four supplied
screws (+PSW5 × L16).
Soft cloth
Align the hook with the circle on the
rear side of the TV or monitor.
Notes
• When using an electric screwdriver, set the torque setting
to approximately 2 N·m {20 Kgf·cm}.
• Be sure not to use any screws other than the supplied ones
(+PSW5 × L16) when attaching the hooks.