Confirming The Completion Of The Installation - Sony SU-WL51 Gebrauchsanweisung

Step 5:
Installing the TV or monitor on the
Plate Unit (Continued)
3
Install the TV or monitor onto the
Plate Unit.
1 Insert the screws (+B6×L20, supplied) into the
screw holes on the outer left and right sides of the
Mounting Hook Unit support shafts, and tighten
them temporarily.
Note
If the temporarily attached screws protrude inside the
Mounting Hook Unit support shafts, the lower hooks of the
Mounting Hook Unit cannot be fitted in (procedure 4).
2 Hitch the upper hooks of the two Mounting Hook
Units on to the support shafts of the arms.
3 Place the lower hooks of the two Mounting Hook
Units so that they touch the front side of the
Mounting Hook Unit support shafts.
4 Slightly push the TV or monitor toward the Plate
Unit and upward, to hitch the lower hooks of the
two Mounting Hook Units to the Mounting Hook
Unit support shafts.
5 Confirm the eight hooks are firmly hooked on the
four shafts on the Plate Unit.
Mounting Hook Units
10
(GB)
Tighten the screws
to halfway so that
they do not
protrude from the
opposite side.
6 Firmly tighten the securing screws screwed in
temporarily in procedure 1.
WARNING
Be sure to tighten both left and right securing screws
firmly. If you fail to do so, the TV or monitor may fall
when it is pushed upward and cause injury.
Confirming the
completion of the
installation
Check the following points.
• The eight hooks of the Mounting Hook Units are
firmly hooked on the four shafts of the Plate Unit.
• The cord and the cable are not twisted or pinched.
• The two securing screws on the Mounting Hook
Unit are securely tightened.
WARNING
Incomplete installation may cause the product falling and
result in injury or product damage. Also, improper
placement of the AC power cord, etc., may cause fire or
electric shock through a short circuit.
Be sure to confirm the completion of the installation for
safety.