Sensor Calibration - Pulsar XQ30 Handbuch

Powering on and image setup
Open the lens cover (1).
Turn the unit on with a short press of the ON (11) button.
To obtain a crisp image of the icons on the display, rotate the dioptre
adjustment ring (7). After this there is no need to rotate the dioptre
adjustment ring for distance or any other conditions.
To focus on the object being observed rotate the lens focusing ring (2).
To set up display brightness and contrast and continuous zoom,
please refer to the HOT MENU FUNCTIONS section.
After use, hold down the ON button to turn the unit off.
9
ZEROING
The sight features two zeroing methods - "one shot" zeroing and using
FREEZE function.
Zeroing should be done at operating temperatures, by following the order
of these steps:
Mount the rifle with the sight installed on a bench rest.
Set a target at a certain distance.
Adjust the sight according to the instructions of section "Powering on
and image setup".
Select the zeroing profile (see main menu option «Zeroing
Profile» )
Aim the firearm at the target and take a shot.
If the point of impact does not match the aiming point (centre of the
sight's reticle), hold down the M (4) button to enter the main menu.
Enter the submenu "Zeroing"
Set the zeroing distance value (see main menu option "Zeroing" =>
submenu "Add new distance"
Enter the submenu with a short press of the M button
Select icon with UP/DOWN buttons. Press briefly the M button.
Additional menu for zeroing parameters setup appears on
the display
An auxiliary cross appears in the centre of display,
and coordinates of the auxiliary cross X and Y appear in
the top right corner (see Pic. 5).
9
with a short press of the M button.
).
0
Select icon with UP/DOWN buttons. Press briefly the M button.
Holding the reticle in the aiming point, move the auxiliary cross
horizontally or vertically with UP/DOWN buttons relative to the reticle
until the auxiliary cross matches the point of impact.
Attention! Not to hold the reticle in the aiming point, you can use the
FREEZE function – freezing the zeroing screen (refer to main menu
option "Zeroing" => submenu "Distance" => submenu "Zeroing
parameters setup" => submenu FREEZE
Switch between movement
directions of the auxiliary
cross from horizontal to
vertical with a short press of
the М (4) button.
Save the new position of the
reticle with a long press of the
М button. Message "zeroing
coordinates saved" confirms
successful operation.
Menu exit takes place. The reticle will now move to the point of impact.
Exit the submenu,take another shot - the point of impact should now
match the aiming point.
10

SENSOR CALIBRATION

Calibration allows levelling of the background temperature of the
microbolometer and eliminates image flaws (such as frozen image,
vertical stripes etc.).
There are three calibration modes: manual (M), semi-automatic (SA) and
automatic (А).
Select the desired mode in the menu option "CALIBRATION"
Mode М (manual). Close the lens cover, turn the sight on with a short
press of the ON (11) button. Having finished calibration, open the lens
cover.
Mode SA (semi-automatic). Calibration is activated with a short
press of the ON button. You do not have to close the lens cover (the
sensor is closed with the internal shutter automatically).
Mode А (automatic). The sight calibrates by itself according to the
software algorithm. You do not have to close the lens cover (the
sensor is closed with the internal shutter automatically). User
assisted calibration with the ON button is allowed in this mode (in
semi-automatic mode).
).
A100m
windage
x=31.00
y=26.00
Pic.5
.
10